Hello All,
I know this a subject that has been covered in several threads but here goes another. I am in the planning stage of upgrading my 6 speakers system, here are my tentative plans:
1. Remove all existing "Alpine" speakers
2. Install a pair of JL Audio C2-350X 3 1/2"two-way in the dash corners
3. Install a pair of JL Audio C2-650 6 1/2" components in the doors
4. Install a pair of JL Audio C2-650X 6 1/2" two-way in the rear deck
5. Install a JL Audio 8W3V3-4 8" subwoofer in the center of the rear deck
6. Install a Rockford Fosgate DSR1 Digital Sound Processor via idatalink HRN-AR-CH2 T-Harness with a idatalink HRN-AR-EXT4 extension.
7. Install a Polk Audio PA250.2 2 channel amplifier to drive dash corner speakers
8. Install a Polk Audio PA1100.5 5 channel amplifier to drive doors, rear deck coaxials and sub.
9. Fabricate a custom enclosure to incorporate into the upper trunk/rear deck interior trim panel.
10. Fabricate a custom base to mount amps, LOC, existing compressor and associated power and audio wiring in spare well in place of existing foam block.
I am open to any feedback as I am no expert and I'm sure there are many audiophiles on here with a lot more knowledge and expertise than me.
The photos show the start of the project, I am going to cover the amp rack in black leather, the speaker harness is started and the main power was tapped by drilling into the factory positive battery terminal and bolting my new 4 gauge power lead.
I know this a subject that has been covered in several threads but here goes another. I am in the planning stage of upgrading my 6 speakers system, here are my tentative plans:
1. Remove all existing "Alpine" speakers
2. Install a pair of JL Audio C2-350X 3 1/2"two-way in the dash corners
3. Install a pair of JL Audio C2-650 6 1/2" components in the doors
4. Install a pair of JL Audio C2-650X 6 1/2" two-way in the rear deck
5. Install a JL Audio 8W3V3-4 8" subwoofer in the center of the rear deck
6. Install a Rockford Fosgate DSR1 Digital Sound Processor via idatalink HRN-AR-CH2 T-Harness with a idatalink HRN-AR-EXT4 extension.
7. Install a Polk Audio PA250.2 2 channel amplifier to drive dash corner speakers
8. Install a Polk Audio PA1100.5 5 channel amplifier to drive doors, rear deck coaxials and sub.
9. Fabricate a custom enclosure to incorporate into the upper trunk/rear deck interior trim panel.
10. Fabricate a custom base to mount amps, LOC, existing compressor and associated power and audio wiring in spare well in place of existing foam block.
I am open to any feedback as I am no expert and I'm sure there are many audiophiles on here with a lot more knowledge and expertise than me.
The photos show the start of the project, I am going to cover the amp rack in black leather, the speaker harness is started and the main power was tapped by drilling into the factory positive battery terminal and bolting my new 4 gauge power lead.
