[christianbe]

On the engine dyno this morning here at Arrington Performance:

Checkout our naturally aspirated 461 HEMI pushing out almost 660HP and over 662FTLBS of torque! If forced induction just isn't your cup of tea, then you might want to give this HEMI a good look.

https://www.youtube.com/watch?v=3JYI5W1K1M0&feature=youtu.be

 

[williams rt]

Nice, what CR is that Christian?

 

[christianbe]

Mr. Williams, 10.9 to 1, good sir. This is the new "stage 1" of this motor. There is a "stage 2" in progress that will boast an 11.3 to 1, thitek heads, a larger cam, etc.

 

[williams rt]

Very nice, what is the rough cost of one?

 

[christianbe]

Very nice, what is the rough cost of one?

Pm sent, sir.

 

[HemiShaker]

I'm also interested in the cost and specs on this motor - been looking at your 448 short block. Please PM me...

 

[oilslick]

So did the 461 replace the 468 that you advertised? :4-dontknow:

 

[christianbe]

So did the 461 replace the 468 that you advertised? :4-dontknow:

We can do the 468 as well. We recommend the 461 for the aluminum block config to allow for a rebuild when the time comes. At 468 the we don't feel like there is enough wall thickness if you have to rebuild the motor down the road.

 

[christianbe]

I'm also interested in the cost and specs on this motor - been looking at your 448 short block. Please PM me...

PM sent, sir!