Dodge Challenger Forum banner

1 - 13 of 13 Posts

·
Registered
Joined
·
476 Posts
Discussion Starter #1
I recently installed the Mopar Strut Tower brace and thought I would post the pictures from cutting the stock caps to fit. It's probably delaying the inevitable purchase of a Billettech set of caps, but it looks better to me for now.

I used a Dremel cutting wheel, a file, and a little sandpaper. Not perfect but good enough for now.
 

Attachments

·
Premium Member
Joined
·
1,218 Posts
Clean looking engine compartment! Good job
 

·
What's Old is New Again!
Joined
·
39,476 Posts
I've never seen them cut like that either. Unique! If you are looking at getting aftermarket strut tower covers you could also check into the Drake covers.
 

·
Registered
Joined
·
476 Posts
Discussion Starter #5
The Drakes look cool and look like a great deal price-wise...but unfortunately explicitly state that they will not work with the Mopar Strut tower brace.
 

·
Premium Member
Joined
·
279 Posts
Necessity is the mother of invention! Great Job !!! :smileup:
 

·
Registered
Joined
·
476 Posts
Discussion Starter #11
I went a different way since I did those. These caps are aluminum storage cups with a Mopar decal and held on with a magnet (rare earth).

 

·
Registered
Joined
·
2,039 Posts
I went a different way since I did those. These caps are aluminum storage cups with a Mopar decal and held on with a magnet (rare earth).

looks good, nice and clean
 
1 - 13 of 13 Posts
Top