Dodge Challenger Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,072 Posts
Discussion Starter · #1 ·
Due to a recent project I had to extend my IAT wiring harness to the IAT sensor on the intake tube. I was wondering if someone could take a photo of the connector showing which colored wire goes to which side of the connector. Thank you to anyone can help

This is the connector I'm talking about



These are the two wires I'm asking about one is blue and one is brown

 

·
<<< Bending Time & Space >>>
Joined
·
16,087 Posts
I can't help either. My wires are both dark blue with light and dark green stripes.

1 K21 20DB/LG IAT SIGNAL
2 K900 20DB/DG SENSOR GROUND
 

·
Registered
Joined
·
1,072 Posts
Discussion Starter · #4 · (Edited)
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top