Dodge Challenger Forum banner

1 - 14 of 14 Posts

·
Mopartial to Challengers
2013 Dodge Challenger R/T Classic
Joined
·
9,683 Posts
Looks really good! I hope to install mine soon.

Still waiting on my shift insert plate to arrive from Billet Tech....
 

·
Registered
Joined
·
476 Posts
Discussion Starter #4
It's a Mopar, part number 82212927 for mine. It's a couple of minutes to install. On the 2010 r/t ...

1. Pop the chrome collar down
2. Use a screwdriver and spread the white plastic slightly while pulling up to release the stock knob. Instructions said to remove a retaining clip -- no such thing on the 2010 R/T.
3. Remove the chrome collar.
4. Slide on the new one, tap down gently as needed to seat...being careful not to mar the top.
5. Put on the sides and use the 3 included screws to tighten.
 

·
Waiting for beautiful fall colors!
2020 Go Mango Scat Pack
Joined
·
28,439 Posts
Andy,
Just wondering what kind of shifter came on the SRT auto? I also replaced my shifter and put on a T-shifter. I also like the pistol grip with the Mopar label. May have to get it and just use both! (Probably a woman thing to have two shifters!).
 

·
Waiting for beautiful fall colors!
2020 Go Mango Scat Pack
Joined
·
28,439 Posts

·
Andy
Joined
·
3,906 Posts
ya...that pretty much describes it!!! I like the T Handles as well...gives them that retro look for sure. So many options, so little finances!!!!!
 

·
What's Old is New Again!
Joined
·
39,532 Posts
Looking Good! :smileup:
 
1 - 14 of 14 Posts
Top