[sullivan]

Not really sure what it is and its bumming me out.

Alignment seems fine and spot on, and I lifted up the front end and kinda inspected everything. Wheel bearing, ball joints, and tie rod ends seem to be fine.

I don't know what it is though, it doesn't happen at high speeds, only when creeping through parking lots or 20-35mph roads on bumps.


Any ideas?

 

[erik108]

sounds like a typical ball joint sound to me !!
usually hear then going over a bump , a pot hole

 

[bad8nti]

Also check your sway bar bushings. My Magnum had a squeak and when I got under it while it was on a drive-on rack, I was able to move it up and down and isolate the squeak to the sway bar. I took the U-retainers off and regreased the bushings with Lucas Red HiTack Grease. Took care of the squeak.

 

[sullivan]

MEHHH, Do you know if the ball joints on this car are removable or do I need to buy new control arms as well? My dodge ram had upper ball joints that were not removable.