[JB1]

Decided to use my time off today and modifiy my rear tails to include the center section for brakes and turn signals.

http://www.youtube.com/watch?v=XntXZTZPihw


http://bigislanddodgechallenger.blogspot.com/2012/06/step-by-step-8-bulb-brake-lights-and-4.html

 

[vin57]

Nice job!!...nice alternative to the sequentials! You should post a how-to on it :smileup: reps to you

 

[JB1]

thanks, wish I could take credit for the idea. Theres a how too link at bottom of first post with good pics etc.

 

[vin57]

thanks, wish I could take credit for the idea. Theres a how too link at bottom of first post with good pics etc.

Great!! I'm sure others will consider trying it :smileup:

 

[JB1]

The center tail bulbs are actually dual filament from factory so just reuse them. Literally all you need is some 16-18ga wire and the sockets. I didnt use the twist caps like he did but how you make the connections is up to you (push locks, crimp, solder etc). I used green wire to connect to the grn/wht stripe and yellow wire that connects to the yel/wht stripe. I also used a male/fem type connection to connect the 2 wires from lower lights to the center harness where the center tails connect on trunk lid so I can easily unplug and remove center light when needed.

This mod cost me about $30.

heres the sockets I purchased and they fit perfectly, I even like them better than the factory sockets lol. You might can buy these locally, just search using the part number from the listing.


2 3157 3357 4157 Brake Turn Signal Light Socket Harness Wires for LED or Stock | eBay