Dodge Challenger Forum banner
Cancel
Create thread New Garage Forums

Rocker panel installation

Jump to Latest
15K views 17 replies 5 participants last post by  Derecho  
M
#1 ·
Afternoon everyone,

Anyone have experience installing the plastic rocker panel beneath the driver's door? I hit a rock this past weekend and put a big gouge in it. I pick up the new piece this afternoon. The parts guy told me over the phone that it looked to him from the picture that it was a snap in piece with double sided tape. Thanks.
 
Discussion starter · #3 ·
Thanks for the info. Picked it up yesterday and there appears to be four screws, two at each end, that screw into the wheel well. Other than that, a bunch of snaps. There were only two double sided tape pieces on the underside and I wonder if that will be enough. I had this rocker panel molding replaced once before, under warranty, because it bulged out. I'll take a look at how the dealership attached the rocker panel when I take it off. I may need to augment the double sided tape that came with the new rocker panel.
 
Dodge Challenger Forum
posts
1.8M
members
44K
Since
2006
A forum community dedicated to all Dodge Challenger owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, Hemi Mopar power, power-adders, and more!
Full Forum Listing
Explore Our Forums
Newbie Check In! Dodge Challenger General Discussion Challenger Performance Mods - Engine - 5.7L HEMI Custom Challenger Exterior Mods - Body Dodge Challenger Scat Pack Forum